All Forum Posts

Hi guys

Hello  and good morning  just wondering if March issue  has been sent as yet I don't  seem to have  the latest copy  many thanks  dave in wet Hampshire 

Hi,

I have a Dominator 7 with a early model clutch. Its a project that I have and I am in the phase of rebuilding the clutch.

Hi all,

I've had my 72 Roadster back together for a couple of weeks and am getting the testing miles in when weather allows. My bike came with a set of Norvil pipes and peashooters.

Do the wideline and slimline frames have the same size mudguards 

I bought my 2A Commando about 40 years ago and at some point I checked the Isolastic tolerances. That was at least 25 years ago so I thought I would check them again - whether they needed it or not.

Always used Morris 20/50 golden film in primary case and forks on my 1952 Es2 Norton. No issues.

I took my head and barrels off my 1970 Commando in situ before I found my knackered cam and had to do a full rebuild.

Can I fit a later Rubber faced timing chain Tension adjuster to my Dommi 88 and has anyone ever come up with an automatic adjuster ?

Good morning all,

In the quest to cure the top end oil leaks on my Electra I need a new cylinder barrel base gasket which sadly isn't listed in the NOC shop.   Does the navigator gasket fit or is it a matter of making your own?

Need to know having read my Domnator service notes V1.2 manual ( Page 20) if the said `grub screw` talked about is the one shown (I think ) in the top photo ?

What, if any, will the club's stance be regarding the law suit against parts suppliers?

Press release issued by Andover Norton International.

This morning Andover Norton posted a Press Release hinting at an issue regarding infringement of rights. It looks like ANIL are about to square up against Norvil in a legal boxing ring.

Does anyone know the whereabouts of a black 1967 Atlas, registration PLH314E. I owned it for a while after I passed my test. It was a bit of a leap up from my D1 Bantam!

I’ve just received my reconditioned Commando Speedo and tacho back from Stuart Walker of Classic Speedometers.

Hello All,

Can anyone tell me the dimensions of the rubber sealing strap which goes around the inner chaincase, and whether the rubber is relatively hard or soft?

My buddy saw this pic on facebook, and thought I’d like it.

Hi, a Norton acquaintance of mine has bought a Freebird luggage monotrailer. He plans to hang the trailer behind a Norton Commando and asked me if I knew anyone who has experience with a mono trailer behind a Commando.

Gents,

After struggling to set the timing I realised it was too far advanced due to the points gap being too big.

Is this the preferred injector oil?

Silkolene Comp 2 Pre-Mix Engine Oil | 10% ($7.72) Off! - RevZilla

At the Bristol Bike show today I met the seller who sold me the wipac headlight - I didn’t realise he had 2 more!

Hi all,

I entered the rally but have not had any kind of reply so I don't know if I have been successful or not. is this common?

Hi all

Am returning to a job I tried to "bottom" years ago, to try to sort the rear wheel on the 650SS, year 1966.

Hello  Has anyone had recent experience of fitting an Andover Norton luggage frame (06.7324) to a Fastback?

Can anyone advise on the correct position of the "MAXIMUM OIL LEVEL" & "MINIMUM OIL LEVEL" decals on my Atlas oil tank? Not sure exactly where they should go