Singles

Evening gents,

I am currently disassembling my wheels for a rebuild and I am having trouble removing the front brake drum after removing the three barrel nuts. Is there a special removal for this or is it just needing some persuasion from a rubber mallet? The manual says nill!   

Thanks.

Hi the correct carb for my 16h is a 276AT/1BE however this is completely worn out and needs replacing,would any stub fitting 276 with the correct jets etc work,I'm also at a complete loss as to what the AT/1BE part means.Any help would be appreciated.

Regards

Bob

hello I have recently purchased a 1952 Norton big four. the rear mudguard is pretty much rotted out. it has been bodged in the past with the use of vast amounts of p38 filler. has any one got or know of the whereabouts of another one.many thanks.

hello,

could anyone tell me if the nuts that hold the rear brake drum onto the cotton reel hub are normal thread. they are very tight . can seem to budge them. ive tried shouting at them, but that didnt work.

barry

I have a genuine Ray Petty "bacon slicer' cooling ring, which I've removed from my Manx and no longer have a requirement for. Any thoughts of value?

Internal diameter 8 3/4"

Outside diameter 14"

Hi to all. Can anyone tell me the length of the clutch rod that goes in a dolls head gearbox. As I have ordered and received one but it seem to be two long. Any help in this matter would be.   

bob 

1948 ES2... Just replaced the cage and rollers in my clutch as the old one was so worn the rollers were falling out.

When I tighten the backing plate nuts the rollers lock up. I have double checked the components and all seems correct.

My only thought is the backing plate might be slightly warped but would appreciate any comments.

Thanks

hi can anybody please advise me .....does this model have the engine number also stamped on the cylinder barrel as well as the crank case thank you richard

Hi, Could someone tell me the correct dynamo for my MO1L Magneto, its for a 1955 ES2 I realize its the 6v long type but after the E3 im seeing different letter combinations , any help would be appreciated. Darren

Does anyone know where I might get a rear wheel sprocket for my 1928 CS1 with the enfield rear hub?

Paul