Gearlever

No. Is the short answer. I was unable to find one for mine. The upright gearbox has the same splines on it so I used a lever for one of them and shortened it in the end, then had to get it replated.

Regards

Andy

Bill:

Can you advise the part number of the gearlever item you are looking for?

Mike

Hi mike, I have a couple of NOS short levers spare, no idea if correct though!.

I found upright/dolls head levers a lot easier to get hold of. Either new repro ones or old ones at jumbles and on eBay.

A bit of caution is needed , The splines do not always match up. Don't know if they changed with the move to AMC Woolwich production , but new "Norton" ones I have bought don't fit my Bracebridge built bike.so I have continued with my old parts.

Thelater AMC ones are different. But if you go for an earlier upright or dolls head lever it should fit.

Regards

Andy

Hi Bill i was looking through my boxes of spares over the weekend and have found a couple of spare lay down gear change levers my E mail is roger_deadman@yahoo.co.uk

I, too, am in need of one. Just send me a PM.

Many thanks, Geoff Morgan, Pelham, AL USA