gearbox and engine plates

So am I !

Arne

So am I! It seems that Bantam John has the templates but I ordered a set in Sept.2020 and have not heard from him since. Does the Club have drawings of these perhaps?

Bill !

Santa is comming to you !

Since my last posting I came across a set on ebay.

If you like, I can draw around them on a sheet of paper and send you ?

Merry Chiristmas

Arne

Greetings Santa. May the road rise to meet your feet! I feel a bit miffed that I didn't get to them before you did, but your kind and generous offer is most overwhelming. PM me on billnlynatwestnet.com.au. You could even use @ for at. We may be able to scan them and send as a PDF

Have a great Christmas and beware of the virus

Bill Moline

Re:- 

           Inter Engine Plates

             Does the Club have drawings of these perhaps?

Give me a drawing number and I will have a look.

Tony

As this question is related to a camshaft single, you could try talking to:-

camshaftsingles@nortonownersclub.org

Regards

Tony

Bill

I havs ent you an email, sorry for being a bit late.

Regards

Arne

Dear Santa, Congratulations despite virus wind  snow heat and  rain you have finally managed to make it down to Australia. In my chimney mail box this morning came a most wonderful present, a set of drawings for Norton International engine plates.

Seriously Arne to you and your wife my heartfelt thanks. Now that I have your address I will copy all my information onto a stick and send it to you. All the best for 2021

 Bill Moline

billnlyn@westnet.com.au