Light Twins

From pictures I have seen, Electras of that vintage all appeared to have a black frame and tubes and sheet metal was either 2 tone, silver or black.  Mine has chrome fenders and an odd green colour on the sheet metal and tank.

I need to fit new X rings to the kickstart and gearchange shafts. Am I right in thinking that to fit O rings to the inner gearchange spindle that I take the inner cover off and then the gearchange components can be slid out?

I have bought the oil filter kit for the Navi but at a quick glance I cannot figure out how it fits. Has anyone fitted one?
I have seen a few pictures of filters fitted, but none that use the NOC Shop parts.

I want to remove the swingarm from my Navigator.  I was hoping it would be a simple job, its looking increasingly like its going to get quite involved!

Any hints and tips please.

I thought I'd just check the tappet clearances on my Electra. I've read about the struggle people have had wriggling the tappet covers past the steering head reinforcing plates.

Hi all . Just been dismantling the clutch on my jubilee restoration and found that there was no 3/8 inch ball bearing in the actuator mechanism and the push rod was slightly bent ( parts ordered ) . What effect would this have on the clutch ? .

The NOC Spares shop lists a clutch cable #25037 for Jubilee & Navigator, Post engine 106838.

Morning all . I just thought I would send an update on my jubilee rebuild. Frame and suspension has been sand blasted etch primed and undercoated along with various other part's. Tank still to clean out . Head blasted and painted.

Hi. Sorry, it's me again.  Do you have to warm the new clutch Rubbers up to fit them, as they're very hard and the assembly won't go back together as they are.  Thank you. 

Hi. Where the brass sleeve goes over the output shaft that leads to the clutch, (see attached picture), should there be a seal or o ring on one side of the sleeve?