Modern Nortons

Have a general question noticed oil leaking out of grommet going into crank case.  I think I need new gasket around case but where to get?  any insight ?  please see picture attached.. not sure if I’m getting reverse pressure inside

I bought a 2019 961 last year - only a few hundred on the clock, no service / inspections carried out at all.  I'm up to around 4,000 miles and it runs like a dream really - but leaks oil.

I just wondered if anyone would tell me how to fit a front paddock stand to a mk 11 961. The stands I have seen have the twin spigot cradle type that fits at the base  of  the fork. However, I am concerned this may break off the front ABS sensor.

NOC 961 Register

Norton boss Hentschel on the MCN website:

Hi,

As a very long shot does anyone know of the existence of a wiring loom for a Mk II 961 which is looking for a good home, please?

2015 possible tank bulge creating little dots under the paint lined up vertically

Can I massage this out?

Just putting this out there. The 961 did not take to the new E10 fuel, however I should have thought about it as my 961 has been mapped and ‘decatt’d’ . The first time I filled her up after the introduction of E10 it started pinking under load.