I have looked at some exploded diagrams but can't seem to discern what would go in the vacant hole in the pic attached: it runs inside towards the sump drain bolt and seems to be threaded for about 4cm. It does not seem to be a crankcase bolt. Any suggestions? Thanks, Ramon
Cheese Head.....
- Log in to post comments
This 'ere 'ole.....
If there is a cheese head screw down in the bottom of the 'ole, does oil run out if you remove it?
Or compression??
Mike
- Log in to post comments
You need a cheese head screw…
You need a cheese head screw and that will tighten the bottom edge of the right hand crankcase to the bottom edge of the left hand crankcase. The threaded portion is in the left hand crankcase. Most likely a whitworth screw. If you leave the screw out you will most likely have an oil leak from that area.
- Log in to post comments
It's easy...
.. to forget about that one when you split the crankcases (literally in some cases!)
- Log in to post comments
.....screw, Grommit.