Navigation

You are here: Home / Messages / Commando / Regulator Position on 850

Regulator Position on 850

Up to Commando

Regulator Position on 850

Posted by mike_steer at October 17. 2017

Where is a good position to fit one of these.  Was hoping to fit mine on the metal plate which previously held the rectifier and bolt the plate in its normal place. This is fine but there doesn't seem to be room enough for the regulator to 'slot' in between the mudguard and frame tube just behind the side panel.  Pics would be great of where you've fixed yours.

regards

Re: Regulator Position on 850

Posted by martin_peacock at October 17. 2017

Not knowing any better, I made a bracket to mount mine at the back of and hanging below the battery carrier.

Attachments

Re: Regulator Position on 850

Posted by karl_nixon at October 19. 2017

Mine is under the coil bracket held by two longer that normal bolts of the four that hold the bracket to the frame. These then have nyloc nuts to hold the regulator but i did have to elongate the regulator mounting holes a little. I put i there as it gets good air flow over it and you can't see it unless you are layed flat on your back on the floor.

Re: Regulator Position on 850

Posted by david_evans at October 19. 2017

Mine is where the air filter used to be before I fitted twin flat slides and a K&N filter

Re: Regulator Position on 850

Posted by christopher_winsby at October 20. 2017

My Podronics type is fittted with velcro on top of the rear mudguard.

Powered by Ploneboard
This is Brio Diazo Plone Theme