Navigation

You are here: Home / Messages / Heavy Twins / Dommi 99 Cylinder Head Removal

Dommi 99 Cylinder Head Removal

Up to Heavy Twins

Dommi 99 Cylinder Head Removal

Posted by Bob Matthews at February 11. 2017

I would like to remove the cylinder head without removing the engine and gearbox from the frame.  Is this possible as I can't seem to find any specific info on it, or am I wasting my time and need to remove the engine first?

Any info would be gratefully appreciated.

 

Dommi photo Dom.png

Re: Dommi 99 Cylinder Head Removal

Posted by David Cooper at February 11. 2017

The short answer is: yes.

Do you have a manual?  Both Haynes and Neill describe it and Haynes includes it in a list of things that can be done without removing the engine.

It is a bit of a Chinese Puzzle to extract it from the gap between the barrels and the frame - partly because the pushrods have to be held up all the time.  There's discussion elsewhere on this site about holding them in place (rubber bands, pet octopus, etc) and relocating them afterwards.  And don't forget there are no less than ten fixings (including the one underneath at the back).

Have fun!

 

David

Re: Dommi 99 Cylinder Head Removal

Posted by John Shorter at February 11. 2017

First, get an owner's manual!  Then check you have the correct spanners.

Re: Dommi 99 Cylinder Head Removal

Posted by Bob Matthews at February 11. 2017

All is good, thanks guys.

Once I realised that by using some packers underneath the head to hold it up fairly close to the frame top rails, the pushrods could be lifted high into the head to clear the barrels and the barrels wiggled out.  Very simple  and easy in-fact once you know how :)

So the next job is to re-fix the broken top fin on the right hand barrel.  It had been badly welded at some time in the past and I presume it will be better to braze it back together rather than weld - as welding is notoriously difficult in cast iron?

 photo IMG_1200.jpg

Re: Dommi 99 Cylinder Head Removal

Posted by terence_rafter at February 11. 2017

I've found silver solder best.

Powered by Ploneboard
Upcoming Events
Andover Norton at Surrey Branch Mar 08, 2017 07:45 PM - 10:45 PM — The Stepping Stones PH Westhumble Street Westhumble, Dorking, Surrey RH5 6BS
Edinburgh Branch at the Scottish Bike Show Mar 11, 2017 - Mar 12, 2017 — Royal Highland Centre, Ingliston, Edinburgh, EH28 8NB
CRMC Track Parade - Snetterton 200 Mar 18, 2017 - Mar 19, 2017 — Snetterton 200 Race Circuit,Norwich, Norfolk NR16 2JU
Surrey Branch at the South of England Classic Show Apr 02, 2017 10:00 AM - 05:00 PM — South of England Showground, Ardingly, West Sussex, RH17 6TL
Tay Valley Branch - Huntygowks lunch meeting Apr 02, 2017 11:00 AM - 04:00 PM — Tullybanocher café, Comrie
Upcoming events…
This is Brio Diazo Plone Theme